AUDIOLINE TEL136 - Setting the Flash Time; Setting the Dialling Method

35
GB
4 Press the Set key, the current setting is shown.
5 Select the desired setting using the Up key ▲ or the Down key ▼.
6 Press the Set key to confirm.
Shortcut: At on-hook state, press the Flash key (R key) to enter LCD
contrast setting directly.
Setting the Flash time
In most situations the flash time of 100 ms should be selected. In some
cases, e. g. when connecting the phone to a PABX, it may be necessary
to switch to 300, 600 or 1000 ms. For further information please refer to
the user guide of the PABX.
1 The receiver is placed on the base.
2 Press the Set key.
3 Press the Up key ▲ three times.
The display shows   .
4 Press the Set key, the current setting is shown.
5 Select the desired setting using the Up key ▲ or the Down key ▼.
6 Press the Set key to confirm.
Setting the dialling method
You can set tone dialling (DTMF = delivery state) or pulse dialling.
In most situations the “Tone“ option should be selected.
1 The receiver is placed on the base.
2 Press and hold the Star key for approx 3 seconds.
3 The display shows the current setting.  for tone dialling (DTMF) or  for
pulse dialling.
Settings