Audionet WATT - Overview of Setup Menu Options

28
Note
• If you do not make any adjustments for longer than 12 seconds, the WATT
will automatically leave the setup menu and return to normal operating mode.
• Whilst in the setup menu, the display brightness is set to 100% for better
readability. The display brightness is automatically reset to its user selected
level after leaving the setup menu.
• If you power down the WATT to stand-by mode, all settings are stored au-
tomatically in the non-volatile memory of the unit. Even after disconnecting
from mains, the WATT will still remember your settings.
All options of the setup menu are explained in detail in the following.
8.1 Overview setup menu
Select Input
Select desired input channel
Global Setup
Main setup menu
Headphones
Headphones mode
Display
Adjust display brightness
Balance Left/Right
Adjust volume balance left/right
AutoStart
Set up automatic start-up mode
AutoOff
Set up automatic power down mode
By-Pass Channel
Select input channel for By-Pass mode
Phono Card
Configure optional phono card
Serial Port
Set up serial control port
Channel Name
Edit name of input channel
(max. 12 characters)
Volume Offset
Adjust volume differences between input
channels
Factory Default Reset
Reset device to factory defaults
Device Info
Get information on device