Audionet WATT - Protection System

41
9 Protection system
Your Audionet WATT and your loudspeakers are protected by a complex pro-
tection circuitry. The display informs about the nature of the detected error in
plain text in case of a malfunction:
Error messag
Possible cause
Overload
Short circuit or defective speaker
Overheating
Ventilation slots covered
High Frequency
Defect source unit
DC Voltage
Exceeding DC voltage level at the output due to de-
fective source unit
Power Failure
(Temporary) breakdown of mains power
Even after powering down the WATT, the error message will still be visible in
the display. Press the key on the front panel to enter stand-by mode.
Important
• Remove the cause of error prior to switching on the WATT again!