9
4 Installation and power supply
Important
• During connecting and removing sources or amplifiers to the WATT, all units
of your audio system have to be switched off to prevent damage to the WATT
or any of the other connected units.
• Please make sure that all cables are in absolute best conditions! Broken shields
or short-cut cables could damage the WATT and/or any other units con-
nected.
4.1 Placement
Important
• It is recommended to place the WATT in a high quality rack or onto a stable
table.
• Do not expose the unit to direct sunlight.
• Do not cover the ventilation slots.
• Do not place the WATT in close range to heat sources like radiators.
• Do not place the WATT on top of other units, especially not on top of power
amplifiers, preamplifiers or similar devices that produce heat. Both units could
suffer damage from thermal overload.
• Do not use the unit in places where it is exposed to vibrations.
• Do not place the unit close to loudspeakers or in corners of a room where
it is exposed to high levels of sonic energy, which might reduce the sound
quality of the unit.
To Next Page