Need help?Do you have a question about the Audiovox Menace PA-S450 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| RMS Power at 4 Ohms | 50W x 2 |
| RMS Power at 2 Ohms | 75W x 2 |
| Bridged RMS Power at 4 Ohms | 150W x 1 |
| THD at RMS Power | 0.05% |
| Signal to Noise Ratio | 90dB |
| Crossover Frequency | 50Hz - 250Hz |
| Bass Boost | 0dB / +6dB / +12dB |
Diagram showing how to mount the amplifier using self-tapping screws and rubber washers.
Explains the function of the power LED as an indicator for operation status and protection circuits.
Guides on setting the amplifier's input level controls for optimal output.
Switches to select frequency filters for bass, high-pass, or full-range audio reproduction.
Adjusts crossover frequency for low-pass or high-pass filter settings based on speaker system.
Accentuates bass frequencies by adding 8 dB boost to the signal at 45 Hz.
Explains fuse protection and replacement using correct ampere rating.
To Next Page
