Need help?Do you have a question about the Audiovox Prestige PAB-250R and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Frequency Response | 20Hz - 20kHz |
| THD at RMS Power | 0.05% |
| Crossover Frequency | 50Hz - 250Hz |
| Bass Boost | 0dB |
| Signal-to-Noise Ratio | 90dB |
Connect the battery terminal (+12V) directly to the vehicle battery for adequate voltage and to minimize noise.
Connect the ground terminal (GND) to a metal part of the vehicle using a wire of the same gauge as the power lead.
Connect the remote turn-on terminal (REM) to the car stereo's 'Auto-Antenna' lead or accessory terminal.
Wire speakers to the amplifier terminals, paying attention to polarity and using appropriate gauge wire.
Use either low-level RCA inputs or high-level speaker inputs, but not both, for optimal performance.
The Power LED indicates the amplifier's status: white for off, green for normal operation, red for protection.
Adjust the Level control to match the car stereo's output for optimal sound without distortion or low output.
Selects frequency filters (OFF, LOW PASS, HI-PASS) to reproduce specific audio ranges for different speaker setups.
Sets the crossover point for LOW PASS or HI-PASS filter settings based on speaker requirements.
Adds +12 dB or +18 dB bass boost at 45 Hz. to accentuate low frequencies.
Allows bass gain adjustment from the passenger compartment using an optional remote control unit.
Protects the circuitry; use only fuses of the same rating. Check wiring if fuses blow consistently.
To Next Page
