OPERATION
Power
Press the (power) button to turn the unit on. Press and hold the power button again to turn the unit off.
NOTE: LCD panels may take longer to respond when subjected to cold temperatures for an extended period of time. In addition, the visibility of the
numbers on the LCD may decrease slightly. The LCD display will return to normal when the temperature increases to a normal range.
Source
Press the SRC button repeatedly to scan the various sources. A source is only displayed when accessible (optional equipment required for some
sources). Available modes include Radio (FM1, FM2, FM3, AM1, AM2), DISC, SD, USB, and auxiliary (AUX IN).
External Devices
External peripheral devices, including a game console, camcorder, navigation unit, iPod, Zune, etc. can be connected to the AUX IN connector
on the front of this unit using the 3.5mm A/V Media Cable (included) Select “SOURCE >> AUX IN” to access auxiliary devices. You cannot
directly control external devices connected to the AUX IN input.
Audio Mute
Press the power button to silence the audio volume appears on the display. Press (power) again to restore volume to the previous
setting.
Volume Control
To increase the volume, turn the VOL/SEL/MENU (rotary encoder) clockwise. To decrease the volume, turn the rotary encoder counterclockwise.
When volume is adjusted, the volume level will be shown on the display panel as a number ranging from “0” (lowest) to “40” (highest).
Audio Menu
Press the VOL/SEL/MENU button to access the audio menu. Press the VOL/SEL/MENU button repeatedly to move through the list of menu
options.
NOTE: Audio settings only apply to the current source (Source Tone Memory). You must make audio adjustments for another source when that
source is active.
• Sub_w: When the Low Pass Filter is activated (see “Menu Operation” on page 9), you can use the VOL/SEL/MENU rotary encoder to adjust
the subwoofer volume from “-14” to “0”.
• BASS: Turn the VOL/SEL/MENU rotary encoder (2) to adjust the bass level from “+7” to “-7”.
• TREBLE: Turn the VOL/SEL/MENU rotary encoder to adjust the treble level from “+7” to “-7”.
• BALANCE: Turn the VOL/SEL/MENU rotary encoder to adjust the balance from “R7” (full right) to “L7” (full left).
• FADER: Turn the VOL/SEL/MENU rotary encoder to adjust the fader from “F7” (full front) to “R7” (full rear)
8
Subject to technical changes
To Next Page
Loading...
Need help?
General
