-12-
BASIC OPERATION
With the Xpress XM7 unit properly installed, activated and con-
nected to your home/vehicle audio system or boom box, pro-
ceed as follows:
Turning Xpress ON and OFF
Set up your Audiovox Xpress XM7 unit using the installation
instructions included in this Kit (Home Kit, or Boom Box Kit), or
with the help of a professional installer.
NOTE: Refer to Antenna Aiming during the installation pro-
cedure.
Press the Power button to turn the unit ON. When the unit turns
ON the XM7 logo will appear for 3-seconds (curved lines on
either side of the XM7 logo gradually appear) (see Figure 4)
followed by the Audiovox logo. These screens will be followed
by the active channel (see Figure 5), which defaults to the last
tuned channel setting prior to power being turned OFF. When
the unit is shut OFF the XM logo will appear and the curved lines
on either side of the XM7 logo gradually disappear.
NOTE: If this is the first time using the Xpress XM7 unit, the
screen will alternately display the preview channel screen and
a number of messages, including: “Activate Your XM7 1-800-
XM RADIO”. If not, go to channel 1 using the Rotary/Select
Knob on the Xpress XM7 unit or the CH Up/Down buttons on
the remote control.
Figure 4. XM and Audiovox Logo Power ON Screen
Figure 5. Active Channel Screen
To Next Page
Loading...
Need help?
General
