128-7472
9 of 16
-9-
3. Using Other Manufacturer’s Mounts
The XMC10 Cradle can also be installed using
othermanufacturer’s mounts; the mounting
plate provisions on the rear and bottom of the
cradle provideyou with two mounting options
within the vehicle using various vehicle-specific
aftermarket brackets.
4. Installing the Xpress XM
®
Receiver into the Cradle
Install the Receiver as follows:
a. After making sure the connectors and guide pin
hole are properly lined up, gently lower the
Xpress XM
®
Receiver into the cradle and press
down on the Xpress XM
®
Receiver to mate the
connectors together. The raised detent on the
cradle will enter the notch on the rear of the
Receiver, indicating the Xpress XM
®
is properly
seated.
b. The Xpress XM
®
Receiver should now be
secured inthe cradle
SCREW HOLES
(2) FOR DIRECT
HARD MOUNTING
PLASTIC LINER
AND ADHESIVE
BACKING
SWIVEL
ADJUSTMENT
SCREW
SWIVEL
BRACKET
SIDE (HORIZONTAL)
MOUNTING
CONFIGURATION
VERTICAL
MOUNTING
CONFIGURATION
XMC10
CRADLE
ASSEMBLY
To Next Page
Loading...
