auna 388-BT - Phono

34
EN
PHONO
• Remove the stylus protector. Make sure that the tone arm is being
detached from the tone arm rest before operating and that it is re-
secured again afterwards.
• Select to “ Phono ” function (6). Then press the BT/Phono button (17) to
“PHONO” position.
• Set the speed selector to the proper position depending on the record
to be played.
• Place the record on the platter (use the spindle adaptor if required).
• Lift the tone arm from the rest and slowly move it to the record side.
The platter will start to rotate.
• Place the tone arm to the desired position of the record.
• Adjust the volume to the desired level.
• At the end of record, the platter will automatically stop rotating. Lift the
tone arm from the record and return it to the rest.
• To stop manually, lift the tone arm from the record and return it to the
rest.
Remarks: As some kind of record the auto-stop area was out of the
unit setting, so it will stop before the last rack nish. In this case, select
the auto-stop switch to “ o “ position, then it will run to the end of
the record but will not stop automatically (turn o the power button
or switch back the auto-stop switch (34) to “ on “ position to stop the
platter rotate). Then put back the tone arm to the rest position.
LINE OUT CONNECTION
Connect the system to your hi system by connecting the line out socket
(32) to the auxiliary input socket with an RCA cable (not included).