auna 388-BT - Cassette Encoding

39
EN
Cassette encoding
• Plug in the USB pen drive for recording (make sure it had enough empty
space).
• Set the function button (6) to “Tape “ mode and then press the “ record “
button (3) directly.
• The LCD display (2) with show the word “ USB “ and ashing, after then
display & ashing. Now the system is starting the encoding
mode.
• Start playback of cassette tape(at either deck 1 or 2) which the track you
prepare to encoding to MP3 format.
• After nish of recoding, press and hold the “ Record “ button (3) until
the symbol & disappear and resume to “ Tape“ mode on LCD display (2).
File copy (USB -> SD / SD -> USB)
The system allow to copy the les from the USB source to SD/MMC card by
pressing RECORD (3):
(1) Copying 1 track (assume copy from SD card to USB mode):
• Perform normal playback of the track at SD/MMC card you want to
copy,
• Press “Record“ button (3) during the playback of the desire track, unit
will display & ashing. Copying is performing now.
• After copying is completed, unit will stop playback automatically.
(2) copying all tracks (assume copy from SD card to USB mode):
• Select “ SD “ mode and then insert the SD/MMC card you want to copy.
• After reading of card information is completed, press the “Record“
button (3) and the unit will display & ashing. Copying is
performing now.
• After copying is completed, unit will stop automatically.
Encoding bitrate (by remote handset)
You can select the desired bitrate during encoding, the higher bit rate will
generate better sound quality and occupy more space of memory. The
selectable range is from 32 / 64 /96 /128 / 192 / 256 kbps respectively
• Set in “ Phono “ function (6) & remain stop mode.
• Press the “Info“ function and the LCD display (2) will show the default
bitrate (128 kbps)
• Press skip buttons (13,24) to select the desire bitrate for encoding.
• Press again the “Info“ to conrm the setting and the LCD display (2) will
resume to “Phono“ mode.