auna KR-140 - FM Radio; FM Stereo Operation

31
EN
- It is not suitable for household room illumination
FM RADIO
• Short press the POWER (4) button to power on the device and use FM
radio from clock display mode. (The FM radio mode will start rst as
system default)
• In power on mode, short press the POWER (4) button to power o.
Use FM Stereo Radio:
• Make sure that the FM wire antenna is well adjusted and xed at good
position; it will increase for radio reception.
• Adjust Volume Level
• Rotates the “Adjustment (16)” button to “- ” for decreases volume.
• Rotates the “Adjustment (16)” button to “+ ” for increases volume.
FM Mute
• In you want to mute the radio sound for a while, short press the “ / (12)”
button, the sound will mute and the FM radio frequency is blinking as
identify.
• Short press the “ / (12)” button to resume.
FM Station
• The rst time use the FM radio function; the frequency 87.5MHz will
show on LED segments display and wait for tuning radio stations;
• However, last used radio channel frequency being recall for FM radio,
when you switch mode in-between the FM mode and BT mode, or
power o and on the device.
Manual Tune Radio Frequency:
• In FM radio mode;
• Press the “TUN / (10)” or “TUN / (11)” button for steps frequency
down or up to receive next station, each press will step down or up the
frequency by 0.1MHz.
• Press the “TUN / (10)” or “TUN / (11)” button quickly until to your
desired radio frequency of radio station. Or;
• Long press the “TUN / (10)” or “TUN /  (11)” button for 2 seconds to
entry into manual searching mode. This mode allows keeping tuning
down / up and being stop until next radio station frequency is received.
Manual Store for Tuned Radio Frequency into Preset Memory:
• After the above mentioned manual tune radio frequency, the tuned
current station’s frequency can be stored by;
• Long press the “PRE/MEM (6)” button, the preset “P01” will appear and
blinking on display.