auragen G5000 - Subject Page

020530E MAN-050-200, MAIN INSTALLATION MANUAL Page
AUTOMOTIVE AURAGEN
®
MAIN INSTALLATION MANUAL
iii
TABLE OF CONTENTS
Subject Page
Figure 3-26: 120 /240 VAC 20 Amp Power Connection to AC Only ECU ...............
.
3-19
Figure 3-27: ECU Output Power / Hard Wire Connection........................................ 3-20
Figure 3-28: 120 VAC, 40 Amp Power Connection to AC Only ECU.......................
.
3-21
Figure 3-29: AC/DC ECU Connection Arrangement (Typical).................................. 3-22
Figure 3-30: ECU Output Power / Hard Wire Connection........................................ 3-23
Figure 3-31:120 VAC, 20 Amp Power Connection to AC/DC ECU..........................
.
3-24
Figure 3-32: ECU DC Power and Ground Terminals...............................................
.
3-25
Figure 3-33 DC Power Cable Connect at ECU........................................................ 3-25
Figure 3-34: DC Power Cable Connect at Battery...................................................
.
3-25
Figure 3-35: DC Power Cable Terminal Boot........................................................... 3-26
Figure 3-36: DC Ground Cable Connection at ECU................................................ 3-26
Figure 3-37: DC Ground Cable Connection at Battery............................................. 3-26
Figure 3-38: 14 Volt Jumper Installation..................................................................
.
3-27
Figure 3-39: DC Only Cable Installation - For Reference Only................................
.
3-28
Figure 3-40: DC Power Cable Connect at ECU....................................................... 3-28
Figure 3-41: DC Power Cable Connect at Battery...................................................
.
3-29
Figure 3-42: DCPower Cable Terminal Boot............................................................ 3-29
Figure 3-43: ECU Output Power/Hard-wire Connection........................................... 3-30
Figure 3-44: 120/240 VAC Power Connection to Inverter/Charger ECU.................. 3-31
Figure 3-45: Inverter/Charger System DC Cable Routing........................................ 3-32
Figure 3-46: Cut Red and Black Wires....................................................................
.
3-33
Figure 3-47: Insulate Ends of Red and Black Wires................................................
.
3-33
Figure 3-48: Remove Output Wires from Terminal Strip.......................................... 3-34
Figure 3-49: Install AC Output Filter Plate ..............................................................
.
3-34
Figure 3-50: Install Output Filter .............................................................................
.
3-34
Figure 3-51: Install Wires on AC Output Power Board............................................. 3-34
Figure 3-52: Install Wires on AuraGen Input Filter................................................... 3-35
Figure 3-53: Install Ferrite Filter on Signal Harness ................................................ 3-35
Figure 3-54: AC Output Reference Colors............................................................... 3-35
Figure 3-55: Manual Transfer Switch System.......................................................... 3-36
Figure 3-56: Manual Transfer Switch Features........................................................ 3-37
Figure 4-1: AuraEngr Password Dialog Box............................................................
.
4-2
Figure 4-2: AuraEngr Main Screen.......................................................................... 4-3
Figure 4-3: Configuration Dialog Box....................................................................... 4-3
Figure 4-4: Find Modem Selection........................................................................... 4-3
Figure 4-5: AuraEngr Password Tab Dialog............................................................
.
4-4
Figure 4-6: Go-On-Line Display............................................................................... 4-4
Figure 4-7: AuraEngr On-line .................................................................................. 4-4
Figure 4-8: AuraEngr Logon Dialog Box ................................................................. 4-5
Figure 4-9: AuraEngr Main Screen.......................................................................... 4-5
Figure 4-10: Configuration Dialog Box.................................................................... 4-5
Figure 4-11: AuraEngr Main Screen........................................................................
.
4-6
Figure 4-12: RegistrationDialog Box........................................................................ 4-6
Figure 4-13: AuraEngr Main Screen .......................................................................
.
4-6
Figure 4-14: AuraEngr Program Upload .................................................................
.
4-6
Figure 4-15: ECU Installation Window..................................................................... 4-7
Figure 4-16: ECU System Status Monitor................................................................ 4-7
Figure 4-17: Control Panel LED Codes - Non-Inverter/Charger Systems...............
.
4-10
Figure 4-18: Control Panel LED Codes - Inverter/Charger Systems....................... 4-11