17 US-EN
After successful reception of the WWVB
radio signal, the
WWVB symbol
2
is dis-
played continuously in the LC display.
Note: Do not move the temperature station
while it is receiving the signal. This could oth-
erwise interfere with reception. If synchroni-
zation fails during initial set up, try changing
the location (e.g. place the temperature sta-
tion near a window).
Reception may be considerably reduced by
obstructions (e.g. concrete walls) or sources
of interference (e.g. other electrical devices).
If the reception of the radio signal continues
to be interrupted, you can set the time and
date manually (see “Setting the lan-
guage / time zone / time / date manually”).
Wall-mounting the temperature sta-
tion and / or the outdoor sensor:
Note: This step requires an electric drill and
a crosshead screwdriver.
DANGER TO LIFE,
RISK OF INJURY AND PROPERTY
DAMAGE! Carefully read the instructions
for use and safety notes for your drill.
DANGER TO LIFE! Be
careful that you do not hit electrical, gas or
water lines when drilling into the wall. If nec-
essary, check the wall with a wall scanner
before drilling.
To Next Page
Loading...
