- 13 -
Trends
Your radio controlled weather station can show trends 10 for the
weather data values temperature and humidity for the station and the
sensors 1-3.
Humidity/temperature rising
Humidity/temperature steady
Humidity/temperature falling
Maximum and minimum values
The radio-controlled weather station begins to record the maximum
and minimum temperature and humidity values when the batteries are
inserted.
Press the up-button 25 briefly to show the maximum values for
temperature and humidity of the station 19 and the sensors 1-3 on the
display 12.
Briefly press the up-button 25 repeatedly to show the minimum
value for the temperature and humidity of the station 19 and the
sensors 1-3 on the display 12.
To delete the maximum and minimum values, press and hold the up-
button 25 for 3 seconds. The stored values are deleted and the radio-
controlled weather station will begin to record new values.
Battery level indicator
If the battery charge is too low to power the radio controlled weather
station, the sensors and data transmission, the battery level indicator
13 or 18 will appear on the display. The batteries should be
replaced in all devices as soon as possible. Restart the weather station.
Channel setting for sensors 1-3
Your radio-controlled weather station can be used with up to 3 sensors
at the same time. Open the battery compartments of the sensors 41
and set the channel (1, 2, 3) you wish to use for each sensor using the
channel selection switches 40. The radio-controlled weather station
will now receive the signals from the sensors 1-3 and the signal
reception symbol 17 will appear on the display of the radio-
controlled weather station. To manually transmit the measured data
from the sensor to the radio-controlled weather station, press the TX-
button 43. Press the °C/°F button 42 to select the temperature unit
°C-Celsius and °F-Fahrenheit. Close the battery compartment.
! Note: The sensors must be set up within a maximum of
100m from the weather station with no obstacles.
The sensors flash briefly as they collect data from the environment.
To Next Page
Loading...
