Stand-Alone Mode (Sound-Active, Auto Mode)
1. This mode allows a single unit to run to the beat of the music, or the unit will auto change in Auto Mode.
Press the <MODE> button until is displayed “ SLAE “.
2. Use the <UP> and <DOWN> buttons to locate the desired program ( FLAS, FAdE, FbdE, ACC-, Sud1,
Sud2 ).Some programs are static, and some can trigger to sound. See the Menu Values section on the
previous page for a complete list of programs.
3. Each program has settings which can be configured by pressing <ENTER> while the program is
displayed. Press <ENTER> while the program is displayed. Use <UP> and < DOWN> buttons to the
desired setting ( Level 00 – 12 ) and press <ENTER>, Use <UP> and <DOWN> buttons to change the
level ( 00 – 12) and press <ENTER>.See the Menu Values section on the previous page for a complete
list of settings.
4. Press the <MODE> button to go back to previous Menu.
Static Color Mixing
This function will allow the fixture to select specific colors without the use of a DMX console.
1) Press <MODE> until <r---> displayed then press <ENTER>
2) Use <UP> and <DOWN> buttons to select desired color Red <r--->, Green <9---> and Blue <b--->
3) Press <ENTER>
4) Use <UP> and <DOWN> buttons to select desired value for each color ( from 000 – off to 255 –
brightness )
5) Press <ENTER>
6) Press <MODE> to go back to previous page, repeat steps 2 – 5 to set another color.
To Next Page
Loading...