C300H / C300HI / C300H x4 / C300HI x4
C350H / C350HI / C350H x4 / C350HI x4
101
Engine oil: Filling up
- Remove the dipstick (b) and place a funnel in the opening of the oil filler neck
located above the rocker arm cover.
- Fill the engine to the recommended oil level. See the TABLE OF FLUIDS AND
LUBRICANTS (references and capacities) in this Operator’s manual for oil type
and capacity.
- Start the engine and leave idling for a few minutes. Check the areas around the
oil filter and oil drain plug for leaks.
- Switch off the engine.
Wait a few seconds to allow the oil to flow towards the engine oil pan and then check
the level.
- Top up if necessary.
CAUTION
Do not exceed the maximum level mark. Starting the engine with incorrect oil
levels may cause serious damage. Clean up any spillage. Check the oil level
often and top up where necessary.
Dispose of used oil in authorized centres.
Periodic
Maintenance
Operations
To Next Page
Loading...
