C300H / C300HI / C300H x4 / C300HI x4
C350H / C350HI / C350H x4 / C350HI x4
102
Coolant system (fig. 1, 2)
Level of coolant: Checking
WARNING
Never remove the coolant reservoir cap while the engine is hot. Wait until the
engine has cooled down.
The level of coolant should be between the “MIN” and “MAX” marks on the coolant
reservoir .
If the coolant level is below the “MIN” mark, top up the coolant reservoir with coolant.
Check the engine, hoses and radiator for possible coolant leaks.
C300H / C300HI Model
If the coolant level is below the “MIN” mark, top up with coolant through the coolant
reservoir cap (a) placed under the counterweight’s top cover. Check the engine, hoses
and radiator for possible coolant leaks
C300H x4 / C300HI x4 / C350H / C350HI / C350H x4 / C350HI x4 Model
If the coolant level is below the “MIN” mark, top up with coolant through the coolant
reservoir cap (b). Check the engine, hoses and radiator for possible coolant leaks
Coolant circuit: Draining
The coolant should be changed according to TABLE OF FLUIDS AND LUBRICANTS
(references and capacities), or when the circuit is drained for repair purposes. To do so,
proceed as follows:
- Place a container below the radiator.
- Disconnect the lower radiator hose in order to drain the radiator here.
(fig. 2) Kubota V3600 (fig. 1) Kubota 2403-M
Periodic
Maintenance
Operations
a
max
max
min
min
b
To Next Page
Loading...
