AUSTRALIAN MONITOR AMC+120 - TEST PROCEDURE XXXX-1; Initial AC Checks; THD; Sensitivity

TEST PROCEDURE XXXX-1
MODEL: AMC+120P
Rev A 22/09/08 Original
Outline
1. Physical checks
2. Set up amplifier for test
2.1. Fuse check
2.2. Connections
2.3. Reset controls
3. Power up
3.1. Voltages
3.2. Bias setup
4. Initial AC Checks
4.1. Signal check and gain of amp
4.2. Emitter current check
4.4. Outputs
4.5. Phantom power
5. THD
6. Sensitivity
6.1. Input
7. Bandwidth
8. Phase
9. Current Limit
10. Noise floor / SNR
11. Fan/Thermal check
12. Final check for damage
13. Factory setting
14. Listening Test
14.1. Switch on thump
14.2. Audio quality
14.3. Current Limit