Need help?Do you have a question about the AUSTRALIAN MONITOR SY2200 and is the answer not in the manual?
General| Signal-to-Noise Ratio | >100dB |
|---|---|
| Damping Factor | >200 |
| Type | Power Amplifier |
| Frequency Response | 20Hz - 20kHz |
| Input Impedance | 20k Ohms |
| Inputs | XLR |
| Outputs | Binding Posts |
| Rack Units | 2U |
| Cooling | Fan Cooled |
Details specific protection mechanisms implemented in the amplifier.
Describes the controls and indicators located on the front of the amplifier.
Details the connectors and switches found on the rear of the amplifier.
Explains common causes of hum and noise in audio systems.
Details the function and usage of the signal ground lift switch.
Guides on the correct procedure for turning the amplifier on and off.
Explains how to adjust input sensitivity and gain for optimal performance.
Provides details on the amplifier's input sensitivity and impedance characteristics.
Instructions for cleaning and maintaining the amplifier's cooling fans.
Guidance on identifying, checking, and replacing internal and external fuses.
To Next Page