Need help?Do you have a question about the AUSTRALIAN MONITOR SY 1200 and is the answer not in the manual?
General| Signal to Noise Ratio | >100dB |
|---|---|
| Frequency Response | 20Hz - 20kHz |
| Input Impedance | 20k Ohms Balanced, 10k Ohms Unbalanced |
| Protection | Thermal, short circuit, DC offset, overload |
| Inputs | XLR, 1/4" TRS |
| Outputs | Speakon, Binding Post |
Details front panel controls including attenuators, status, overload, power, and thermal indicators.
Details rear panel connectors, input/output, ground lift, bridge switch, and fuses.
Covers power requirements, mounting, cooling, and input/output wiring for installation.
Covers powering on, level matching, sensitivity, and initial setup on page 16.
Troubleshooting hum issues and using the signal ground lift switch on page 17.
Procedure for cleaning fan grilles and blades to ensure optimal cooling.
Guidelines for checking, replacing, and understanding the purpose of fuses.
Detailed technical specifications for SY400 and SY800 amplifier models.
Detailed technical specifications for SY1200 and SY1600 amplifier models.
Detailed technical specifications for SY6125 and SY4200 amplifier models.
Detailed technical specifications for SY400V and SY800V amplifier models.
To Next Page