AUTEC Air series - Page 9

LIIBKU00E1-02.fm 7 AUTEC - Air Series
A8 - Configuration Menu
PAIR 2.0 SERIAL
PAIR 2.0
Checking the “SERIAL N.” saved in the transmitting unit
Perform the following procedure with the STOP pushbutton not activated to check the number saved in the transmitting unit.
1
2
3
4
R
G
?
C1
STARTFUNCT.
1
2
34
R
G
STOP
S1 S2
S3 S4
STARTFUNCT.
1
2
34
R
G
STOP
S1 S2
1
2
3
R
G
4
?
C5
STARTFUNCT.
1
2
34
R
G
STOP
S1 S2
1
2
3
R
G
4
?
C2
STARTFUNCT.
1
2
34
R
G
STOP
S1 S2
1
2
3
R
G
4
?
C3
STARTFUNCT.
1
2
34
R
G
STOP
S1 S2
1
2
3
R
G
4
?
C4
Keep pushbuttons START
and S4 pressed until LED 1
illuminates
The green LED indicates
digits related to C1 (see
note).
If the red LED illuminates,
no “SERIAL N.” is saved.
Press S1, and LED 2
illuminates. The green
LED indicates digits
related to C2 (see note).
Transmitting unit off STOP pushbutton released
Press S1, and LED 1 and
LED 2 illuminate. The
green LED indicates
digits related to C3 (see
note).
Press S1, and LED 3
illuminates. The green
LED indicates digits
related to C4 (see note).
Press S1, and LED 1 and
LED 3 illuminate. The
green LED indicates dig-
its related to C5 (see
note).
If you press S1 once
more, it indicates again
digits related to C1
(LED 1 illuminated).
Transmitting unit with saved “SERIAL N.”
Switch off the transmitting unit
to escape this view.
ESCAPING
Digit “1” : the green LED repeats 1 blink and an off phase.
Digit “2” : the green LED repeats 2 blinks and an off phase.
Digit “3” : the green LED repeats 3 blinks and an off phase.
Digit “4” : the green LED repeats 4 blinks and an off phase.
Digit “5” : the green LED repeats 5 blinks and an off phase.
Digit “6” : the green LED repeats 6 blinks and an off phase.
Digit “7” : the green LED repeats 7 blinks and an off phase.
Digit “8” : the green LED repeats 8 blinks and an off phase.
Digit “9” : the green LED repeats 9 blinks and an off phase.
Digit “0” : the green LED repeats 10 blinks and an off phase.
NOTE