AUTEC Air series - Page 10

AUTEC - Air Series 8 LIIBKU00E1-02.fm
A8 - Configuration Menu
PAIR 2.0 SERIAL
PAIR 2.0
Pairing the units
Once the “SERIAL N.” has been saved and checked in the transmitting unit, it is possible to complete the pairing procedure
as described hereafter.
1. Remove power from the receiving unit and wait until the POWER LED switches off.
2. Power on the receiving unit (LED POWER on).
3. Within 2 minutes after powering the receiving unit, perform the following actions with the transmitting unit unpaired,
switched off, with “SERIAL N.” saved and the STOP pushbutton not activated.
STARTFUNCT.
1
2
34
R
G
STOP
S1 S2
STARTFUNCT .
1
2
34
R
G
STOP
S1 S2
STARTFUNCT.
1
2
34
R
G
STOP
S1 S2
PAIR
1
2
34
R
G
1
2
34
R
G
1
2
34
R
G
STARTFUNCT.
1
2
34
R
G
STOP
S1 S2
Keep pushbutton START
pressed until the red LED is
steady on and the green LED
blinks.
Perform the UNPAIR proce-
dure and save the “SERIAL
N.” again if this signal does not
appear.
Keep pushbuttons START
and S2 pressed until the
ENABLE LED (receiving
unit) and the green LED
(transmitting unit) illumi-
nate
The POWER LED then
switches on
Keep pushbuttons FUNC-
TION, START and S2
pressed until the green
LED illuminates to save this
setting.
Receiving unit powered on. Transmitting unit with saved “SERIAL N.”Transmitting unit unpaired
Transmitting unit off STOP pushbutton released
Keep the
START push-
button
pressed (see
machine's
confirmation)
When the START pushbutton is pressed, the related output on the receiving unit commutes. The signal
(e.g. visual or acoustic) enabled by this output allows to verify that the transmitting unit is paired with
the desired receiving unit.
if the transmitting unit does not result paired with the desired receiving unit, switch off the transmitting unit without
saving the settings and without saving the correct “SERIAL N.”.
Machine maintenance