AUTEC ARM Instruction Manual For The Use And The Maintenance

LIUDY2004_eng-00 AUTEC
12
2 Brief product presentation
2.1 Series, Radio Remote Control and Unit
Autec Dynamic series' Radio Remote Controls are designed to be used on Machines and provide
a command interface to their command and control sy󰘵em, to be used from an appropriate
di󰘵ance and position.
2.2 Conformity with 󰄋andards
This part of the Manual describes:
- the Dynamic series' Radio Remote Control compliance with the 󰘵andards, the requirements
and conditions of use in each Country and
- the di󰘯erent frequency bands, in which the Radio Remote Control is able to operate.
2.3 Contacts and useful addresses
The Radio Remote Controls are produced by Autec Srl – Via Pomaroli, 65 - 36030 Caldogno
(VI) - Italy.
You can find contacts for Autec, its di󰘵ributors, dealers and authorized service centres on the
website www.autecsafety.com.
2.4 Warranty
General warranty conditions are indicated both in the relevant sheet provided together with
this documentation, and in the speci󰘰c page on the website www.autecsafety.com.
2.5 Technical assi󰄋ance and spare parts
If you need technical services and/or spare parts, please refer to contacts provided in the
website www.autecsafety.com.
When applying for technical service to Autec, its di󰘵ributors, dealers and authorized service
centres, the Radio Remote Control's serial number is required; you can find it on the identification
plate on the Transmitting Unit and/or on the Receiving Unit.

AUTEC ARM Specifications

General

Brand	AUTEC
Model	ARM
Category	Remote Control
Language	English