AUTEC ARM Instruction Manual For The Use And The Maintenance

LIUDY2004_eng-00AUTEC
17
4 Frequencies
Dynamic series' Radio Remote Controls can work in the 915-928MHz frequency band.
The Radio Remote Controls' working frequency is defined by market-specific laws
and 󰘵andards. In order for the sy󰘵em “Machine+Radio Remote Control” to be
compliant and therefore to be used, these laws and 󰘵andards mu󰘵 be respected:
if they are not, the Radio Remote Control cannot and mu󰘵 not be used.
Autec cannot be held responsible if the Radio Remote Control is set with frequencies
that are forbidden in the country of use.
4.1 Frequency band 915-928MHz
4.1.1 Frequencies
The radio link between the Units of Autec Dynamic series Radio Remote Controls is e󰘵ablished
at one of the frequencies permitted by the USA, Canadian and Au󰘵ralian 󰘵andards in force
when the sy󰘵em is put on the market.
Frequencies used 256
RF power meets FCC and IC requirements
Channel spacing 50kHz
The Units communicate with one another in dynamic mode, that is:
- They use a working frequency in the 915-928MHz band
- They check that the frequency is free before using it
- They continuously change the working frequency in order to guarantee the radio link even in
the presence of interference.
4.1.2 Countries of usage
Dynamic series' Radio Remote Controls working in the frequency band 915-928MHz can be
used in the USA, Canadian and Au󰘵ralian markets.
Check on the technical data plate of the Units in which markets the Radio Remote Control can
be used.

AUTEC ARM Specifications

General

Brand	AUTEC
Model	ARM
Category	Remote Control
Language	English