AUTEC ARM Instruction Manual For The Use And The Maintenance

LIUDY2004_eng-00 AUTEC
16
Autec allows you to use only the dedicated antenna supplied either with the remote
control or as original spare part. The use of any other type of antenna is prohibited
and will invalidate the warranty.
As required by the document "RSS-Gen — General Requirements and Information for the
Certification of Radio Apparatus", the following indication is valid for all the Units li󰘵ed in the
previous table.
This device complies with Indu󰘵ry Canada's licence-exempt RSSs. Operation is
subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device mu󰘵 accept any interference, including interference that may cause
undesired operation of the device.
As required by the document "RSS-Gen — General Requirements and Information for the
Certification of Radio Apparatus", the following indications are valid for all the Receiving Units
li󰘵ed in the previous table.
Under Indu󰘵ry Canada regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for the transmitter by Indu󰘵ry
Canada. To reduce potential radio interference to other users, the antenna type and
its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.)
is not more than that necessary for successful communication.
This radio transmitter has been approved by Innovation, Science and Economic
Development Canada to operate with the antenna types li󰘵ed below, with the maximum
permissible gain indicated. Antenna types not included in this li󰘵 that have a gain
greater than the maximum gain indicated for any type li󰘵ed are 󰘵rictly prohibited for
use with this device.
Antenna type Antenna gain Antenna impedance
Autec 󰘵ylus λ/4 <2dBi 50 Ohm
Autec 󰘵ylus λ/4 with 5m
RG58
<2dBi 50 Ohm
Autec 󰘵ylus λ/4 with 20m
RG213/U
<2dBi 50 Ohm

AUTEC ARM Specifications

General

Brand	AUTEC
Model	ARM
Category	Remote Control
Language	English