LIUDY2004_eng-00 AUTEC
14
Place the antenna of the Receiving Unit in a position that ensures a minimum
separation diance of 20cm from all the people that can be in the working
area.
Read carefully the section of the Manual where the antenna position is
described, both in the general part and in the specific part referring to the
Receiving Unit.
Autec allows you to use only the dedicated antenna supplied either with the remote
control or as original spare part. The use of any other type of antenna is prohibited
and will invalidate the warranty.
As required by andard FCC Part 15, the following indication is valid for all the Units lied in
the previous table.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device mu accept any interference received, including interference that may
cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the User’s authority to operate the equipment.