LIUDY2004_eng-00AUTEC
THIS PART OF THE MANUAL CONSISTS OF Part B - Information, inructions and warnings
for the Conformity and frequencies (915-928MHz). The Manual consis of Part A – General,
Part B – Conformity and Frequencies, Part C – Transmitting Unit, Part D – Receiving Unit,
Part E – Battery and Battery Charger, plus the Technical Data Sheet.
THIS MANUAL, INCLUDING ALL PARTS THEREOF, AND ALL INSTRUCTIONS CONTAINED
HEREIN, MUST BE READ CAREFULLY AND UNDERSTOOD BEFORE INSTALLING, USING,
MAINTAINING OR REPAIRING THE AUTEC RADIO REMOTE CONTROL.
FAILURE TO READ AND COMPLY WITH ALL APPLICABLE WARNINGS AND INSTRUCTIONS
OR ANY ONE OF THE LIMITATIONS NOTED IN THIS MANUAL CAN RESULT IN SERIOUS
BODILY INJURY OR DEATH, AND/OR PROPERTY DAMAGE.
THE AUTEC RADIO REMOTE CONTROL IS NOT A STANDALONE PRODUCT AND IS
INTENDED ONLY AS A COMPONENT ON A MACHINE:
- ON WHICH AND WHERE THE USE OF A RADIO REMOTE CONTROL IS APPROPRIATE,
- THAT CAN BE OPERATED SAFELY AND IN ACCORDANCE WITH ALL APPLICABLE
LAWS, REGULATIONS AND STANDARDS BY SUCH REMOTE CONTROL.
ACCORDINGLY, IT IS THE RESPONSIBILITY OF THE MACHINE MANUFACTURER ON
WHICH THE AUTEC RADIO REMOTE CONTROL IS INTENDED TO BE INSTALLED, to
perform an in-depth and accurate risk assessment to determine if the Autec Radio Remote
Control is suitable for operating a Machine in conditions of safety and operational
effectiveness, taking into account the conditions of use, the intended uses and the
reasonably foreseeable incorrect ones, so that the inallation, maintenance and use of
the Autec Radio Remote Control, and all its components, are performed only and entirely
in compliance with this Manual and in accordance with all local regulations, safety
andards and regulations (referred to herein as "Laws, Regulations and Standards").
With reference to the USA market the Laws, Regulations and Standards include all safety
rules and regulations of the Occupational Safety & Health Adminiration (OSHA) (http://
www.osha.gov), all federal, ate and local laws, regulations and building and electrical
codes, and all applicable andards, including but not limited to ANSI Standards.
To Next Page
Loading...
Need help?
General
