AUTEC ARM User Manual

Radio remote control lifecycle
AUTEC Dynamic Series
LIDYNE00-02.fm Part A: Description, warnings and instructions
A - 9
ENG
4 Radio remote control lifecycle
To ensure a safe and long-lasting operation of Dynamic series industrial radio re-
mote controls, carefully follow the instructions provided for each stage of the
product lifecycle.
4.1 Transportation and storage
Radio remote controls must always be transported and stored inside their original
packing until they are installed on the machine.
Environmental transportation and storage conditions are given in the following ta-
ble.
4.2 Installation
The radio remote control can only be installed and tested by competent staff that
masters the technical knowledge required to carry out these procedures and is
qualified according to the regulation of the country where the radio remote control
is mounted.
Only if the radio remote control is installed correctly can it be used safely.
Always follow the instructions provided in the technical data sheet to carry
out correct installation.
Please contact the machine manufacturer or the person who decided upon
the installation of the radio remote control for instructions and warnings re-
garding the installation.
4.3 Use
The use of industrial radio remote controls is strictly limited to skilled and properly
trained personnel.
When the radio remote control is installed on mobile machines, switch off
the receiving unit when the vehicle travels.
Temperature Relative Humidity Air Pressure
Transportation
Class 2K3
-40°C to +70°C
(-40°F to +158°F)
Class 2K3
95%
Class 2K3
70 kPa to 106 kPa
Storage
Class 1K5
-40°C to +80°C
(-40°F to +176°F)
Class 1K3
5% to 95%
Class 1K5
70 kPa to 106 kPa

AUTEC ARM Specifications

General

Brand	AUTEC
Model	ARM
Category	Remote Control
Language	English