AUTEC DYNAMIC+P Series - Page 38

LIUPJQ001_eng-00 AUTEC
38
Signals Possible reasons Solutions
At Radio Remote Control 󰘵art
up, the green LED is on and the
red LED emits one long blink and
some short blinks.
At lea󰘵 one of the actuators
corresponding to digital
commands D2-D20 is activated.
Bring the actuators to the re󰘵
position. If necessary, it is
possible to identify the activated
command looking up the table in
paragraph 11.3.
At Radio Remote Control 󰘵art
up, the green LED is on and the
red LED emits two long blinks
and some short blinks.
At lea󰘵 one of the actuators
corresponding to analogue
commands A1-A8 is activated.
At Radio Remote Control 󰘵art
up, the green LED is on and the
red LED emits three long blinks
and some short blinks.
At lea󰘵 one of the actuators
corresponding to direction
commands H1-H8 is activated.
At Radio Remote Control 󰘵art
up, the green LED is on and the
red LED emits four long blinks
and some short blinks.
At lea󰘵 one of the actuators
corresponding to direction
commands L1-L8 is activated.
Whenever the red LED illuminates, the acou󰘵ic signal device activates.
The Transmitting Unit switches off 3.5 minutes after the red LED has been blinking
fa󰘵.
To correctly view signals displayed at the Radio Remote Control 󰘵art up, press the
START pushbutton and hold it pressed until the Transmitting Unit switches off.