Note: No Relearn is needed when the MX-Sensor ID is copied from the
original ID by Activation, OBD or Manual Input. Ensure the
new-programmed MX-Sensor has been put in the same position.
Select the sensor position Click Copy by Input
Input the original sensor ID into a
MX-Sensor (Red mark indicates
OE sensor ID location)
Click OK to program
MX-Sensor Programming Program Success
(the original sensor ID is copied
to the new MX-Sensor)
Copy by Manual Input
(Manually input the original sensor ID to program the new MX-Sensor.)
To Next Page
Loading...
