SUBMENU
SUBMENU IS ACCESSED THROUGH THE MAIN MENU. FIRST GO TO THE APPROPRIATE LEVEL OF
THE MAIN MENU AND THEN FOLLOW THE INSTRUCTIONS IN THE PROGRAMMING FLOW DIAGRAM TO
ENTER THE SUBMENU. PRESS THE “MODE” AND “UP” OR “MODE” AND “DOWN” BUTTONS
SIMULTANEOUSLY FOR 5 SECONDS TO ENTER THE SUBMENU AND ONE BUTTON AT A TIME WHILE IN
THAT SUBMENU.
OPTION:CALIBRATE GAUGE TO ENVIORNMENT: Turn the ignition ON with the engine
OFF. While in the Normal Mode, Press and hold the CENTER and LEFT buttons for five (5) seconds. The
dial face plate will flash GREEN rapidly. Press the CENTER Mode button to save the setting and return
to NORMAL OPERATION.
OPTION:RESTORE FACTORY DEFAULT: While in Peak Playback. Main Menu, press and
hold both the CENTER and RIGHT buttons for 5 seconds. The dial pointer will step 5 times and return
to zero (0). All user programmed setting will be erased and the gauge will return to NORMAL OPERA-
TION
OPTION:DEMO MODE: Displays the features of the meter. The pointer goes up and down the
scale, the dial colors change and the HI, LOW and PEAK warning indicators light. The DEMO MODE
does not time out. If the gauge is turned off in the DEMO MODE, it will start up in the DEMO MODE.
Press the “Mode” button to return the gauge to NORMAL operation.
OPTION:POINTER BRIGHTNESS MODE : The DOWN and UP buttons adjust the dial pointer
brightness to blend in with original manufacturer’s gauges and the owner’s requirements. Press the
MODE button to return to NORMAL OPERATION.
Factory default programming settings:
High Fuel Rail Pressure.............29,500 PSI
Low Fuel Rail Pressure..............12,000 PSI
Programming Instructions for : Pressure
2 1/16” Spek Pro Fuel Rail Pressure Gauge
3
To Next Page
Loading...
