8
1. The antenna should be fitted on the passenger side of the
front windscreen. Ensure that there is a 15cm gap at the top
of the antenna film and a 5cm gap from the side of the
windscreen to the vertical strip of the antenna film as shown.
2. Wipe the inside of the windscreen were the antenna is to be
fitted before fixing.
3. If glass is cold, you may need to warm the glass to ensure
good adhesion.
4. Ensure the glass surface is dry before mounting the antenna
film. Remove the adhesive backing and stick the lower
horizontal section of the antenna film to the windscreen.
Be careful not to touch the sticky side of the antenna film.
5. Stick the antenna to the glass, gently applying pressure to
remove any air bubbles.
6. Remove the adhesive backing from the amplifier block on the
antenna lead, ensuring that you do not touch the terminals or
the sticky surface. Remove the adhesive backing from the
earth sheet on the amplifier block and stick this to the metal
of the A pillar. Note that you do not need to remove any
paint for the earth contact to work.
To Next Page
Loading...
