Autogrow MultiGrow - Bus Terminators

To Next Page

To Previous Page

MultiGrow Installation Guide

Bus Terminators

It is important that each of the Bus Networks has a

terminator at each end of the Bus Network daisy-chain. The

terminator is a method of placing a start and end to the Bus

Network. Every module has a terminator switch built-in. All

these switches must be left off except the switches at each

end of the daisy-chain where they shall be in the on position.

Note:

If a switch is left closed in the middle of the bus it will seriously degrade the communications which may

then work intermittently or not at all.