MultiGrow Installation Guide
V2.0 MultiGrow Installation Guide Copyright© 2018 Autogrow Systems Ltd 7
Module Connections
General
The MultiGrow Controller should be installed in a position well away from water splashes or
mist/vapour. Preferably outside the greenhouse if you intend to operate at high humidity. It should
be mounted in a cool, dry place out of direct sunlight or even inside an electrical panel.
Fit the exterior mounting tabs to the enclosure then screw to the wall. If using the dry wall (plaster
board) anchors, use the longer screws supplied but if fixing to a solid board use the shorter screws.
If the modules are to be located within the greenhouse then a secondary enclosure to protect
against UV and water / moisture may be required. These can be supplied by Autogrow.
See details for the controller and each module below.
MultiGrow Controller
Inside the MultiGrow Controller are the connections for user interface, Bus Network connections and
Ethernet connection.
To Next Page
Loading...
Need help?
General