AUTOHELM Bidata ST30 - User Manual

ST30 Bidata Instrument
ST30 Bidata Service Manual 83009-2 1
Z171
Warning
CE Marking of Equipment/Replacement Parts
If the Autohelm equipment under repair, test, calibration, installation or setting to work carries the European CE mark,
only parts and components supplied or approved for such use by Autohelm should be used in order to maintain
compliance with the relevant CE requirements.
Incorporation, use or attachment, by any means, of parts or components not supplied for or not approved for such use by
Autohelm or, if supplied or approved for use by Autohelm, not properly fitted in accordance with instructions published,
provided or recommended by Autohelm, may cause the equipment to malfunction and, in particular, to become unsafe or
to no longer meet the relevant CE requirements. In these circumstances, Raytheon Marine Europe Ltd excludes liability
to the fullest extent permissible in law for any loss or damage including any liability for its contribution to such loss or
damage by its negligent acts or omissions .
Z171, ST30 Bidata
Service Manual
D4021-1

Summary

Chapter 1. Special Functions

Calibration Lock;Unlock

Prevents accidental changes to calibration values, useful for charter boats.

Boatshow Mode

A demonstration program to showcase instrument features, automatically resets.

Damping

Controls sensitivity to speed and depth changes; adjustable range from 1 to 15.

Chapter 2. Dismantle;Assembly

Spare Parts List

Lists all spare parts for the ST30 Bidata display unit with part numbers.

Chapter 3. PCB Details

PCB Setting

Ensures the PCB is correctly set after fitting for speed and depth display.

Input;Output Signals

Details wire colors, circuit references, and descriptions for input/output signals.

PCB Layout

Illustrates the component layout on both sides of the Printed Circuit Board (PCB).

AUTOHELM Bidata ST30 Specifications