To make the zone warmer or cooler
1 From the Home screen, press the or button to show the Setpoint Adjustment screen. This
screen typically shows one of the following:
The control program may not show
the cooling and heating setpoint on this
screen.
2 Press the
or button to adjust the zone temperature setpoint. The control program
determines how much you can adjust the setpoint.
3 Wait a few seconds until the display returns to the home screen before you press any other
buttons.
To override the schedule
Timed override to an occupied state
1 Press the button one time to override the schedule and put the zone in an occupied state for a
length of time specified in the control program's
field.
2 Press the button to incrementally increase the time. The maximum length of time that you can
override the schedule is specified in the control program's
field.
3 Wait a few seconds until the display returns to the home screen before you press any other
buttons.
During the override, the bottom of the display shows the time (minutes) remaining in the override and
an hourglass to indicate the override state.
• If programmed, you can override the schedule for an indefinite amount of time. To do this, press
the
button one time, then press the button until the display shows
. The override
remains in effect until the schedule transitions to occupied or until you cancel it.
• To cancel an override and return control to the schedule, press the button twice.
ZS Sensors ALC Proprietary and Confidential © 2015 Automated Logic Corporation
Rev. 4/27/2015 All rights reserved
5
To Next Page
Loading...
Need help?
General
