To Next Page

To Previous Page

Setting up the parameters in the counter for 1-Stage Counting:

Select functions: There are 4 modes in CTT, (left to right) timer, counter, tachometer and timer + counter.

–FunC

Select counter functions: 1-stage counting, 2-stage counting, batch counting, total counting, dual counting.

CntFun sta6e1 sta6e2 batCh total dual

C–inPt

––UP down ud–a ud–b ud–C

Select input modes: counting up, counting down, counting up/command down, counting up/counting down,

quadrature input.

C–otmd

F nC rkp

Select output modes: CTT offer 11 output modes, among which mode S, T and D are only valid with input modes

Ud_A, Ud_b and Ud_C.

Select counting speed: Maximum 10Kcps; others 5K, 1K, 200, 30 and 1cps.

C–Sped –10k ––5k ––1k –200 ––30

t–out1

Pulse width of output 1: The default output time is 0.02 second. When the parameter is set to 0.00 second, the

output status will be maintained ON.

–––1

–002 –000

t–out2

Pulse width of output 2: This paramter is adjustable according to different output modes selected. If the output mode is C,

the default output time will be 0.02 second, When the parameter is set to 0.00 second, the output status will be

maintained ON.

–002 –000

–point

Set up the position of decimal point: 0 (no decimal point), 1 (one digit after decimal point), 2 (two digits after decimal

point), 3 (three digits after decimal point).

0 12 3

psCale 1000

Set up pre-scale value: 1.000 (default 1:1) Range: 0.001 to 99.999

–pwers

Save the data while switching off the power: When SAVE is selected, the PV will be saved; when CLEAR is selected,

the PV will not be saved.

Clear save

–rtsr

Set up minimum width of reset signal: Default = 20ms; 1ms is also selectable

––20 –––1

inptlC

Select input signal types: NPN and PNP

–npn –pnp

Cont taCh –mixtime

or or or or

or or

or or or

or or

or oror or

or or

oror

or or

To enter the page for parameter setting of the counter, press

for the main menu for more than 3 seconds.

After the setup is completed, press

for more than 3 seconds under any of the parameter page you are in and

return to the main menu.

www.automationdirect.com

6-3

Digital Counter / Timer / Tach User Manual, 1st Ed.

Brand	Automation Direct
Model	CTT-AN-A120
Category	Timer
Language	English

Automation Direct CTT-AN-A120 User Manual

Table of Contents

Questions and Answers:

Automation Direct CTT-AN-A120 Specifications

Related product manuals