AutomationDirect C-more EA9-T7CL-R - Page 132

Chapter 5 - System Setup Screens
5-41
®
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
EA9-USER-M Hardware User Manual, 1st Ed. Rev. K
Memory – Backup (cont’d)
Warning Messages
If the destination does not have enough space to store
the selected memory size, then the message shown here
will be displayed. Press the OK button to clear the
warning message.
The warning message will read “Not enough Memory
Space in %Device%”.
%Device% will show either “SD1”, “SD2”, or “USB”.
This warning message will be displayed if the backup
Memory device fails or is removed during the backup.
Press the OK button to clear the warning message.
The warning message will read “Backup Failed.
“%Device% cannot be found”.
%Device% will show either “SD1”, “SD2”, or “USB”.
Refer to Chapter 8: Troubleshooting for additional
help.
For any other reason the backup fails, then this warning
message will be displayed. Press the OK button to clear
the warning message.
The warning message will read “Backup Failed”.
Refer to Chapter 8: Troubleshooting for additional
help.