Chapter 5 - System Setup Screens
5-48
®
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
EA9-USER-M Hardware User Manual, 1st Ed. Rev. K
Memory – Clear Memory (cont’d)
Select the data file(s) to be cleared.
This is an example of an SD card or USB memory
that was selected in Clear Memory - Step-1.
The selected file will be highlighted. Pressing again
deselects it.
The Next >> button will stay grayed out until file(s)
are selected.
Selecting Clear All will erase all files located on the
memory device.
This is an example of USB Memory that was selected
in Clear Memory - Step-1.
Notice the ability to select either the Project file, Log
files, Recipe files, or the System files.
NOTE: Firmware files cannot be cleared from internal memory.
This is an example of the Project data file being
selected for clearing.
The selected memory area is highlighted. Pressing
again deselects it.
The Next >> button is now enabled.
Pressing Cancel will deselect the file(s).
Press the Next button to continue.
Clear Memory
CancelNext >>
Log
Total : 0 KB
Recipe
Total : 0 KB
Clear All
Total : 70 MB
Project
Total : 0 KB
<< Prev.
123
Step–2 : Select Data Area to Erase
Clear Memory
CancelNext >>
Log
Total : 0 KB
Recipe
Total : 0 KB
System
Total : 7 MB
Project
Total : 5 KB
<< Prev.
123
Step–2 : Select Data Area to Erase
To Next Page
Loading...