Chapter 5 - System Setup Screens
5-47
®
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
EA9-USER-M Hardware User Manual, 1st Ed. Rev. K
Memory – Clear Memory
This function is used to clear individually selected
data files, or all data files, within the panel’s Built-in
Memory, or any installed memory device such as a
USB pen drive or an SD card.
Select the memory device to clear. If the device is not
available, it will be grayed out.
The Next button is grayed out until a device is
selected.
The selected device is highlighted. Pressing again
deselects it.
When there are more than two available backup
devices, the one selected will be highlighted. If
another is selected, then the highlight will change to
the last one pressed. Only one device can be selected
at a time.
Press the Next button to continue.
To Next Page
Loading...