AutomationDirect C-more EA9-T7CL-R - Page 137

Chapter 5 - System Setup Screens
5-46
®
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
EA9-USER-M Hardware User Manual, 1st Ed. Rev. K
Memory – Restore (cont’d)
Warning Messages:
If the system memory does not have enough space to
restore the selected memory size, then the message
shown here will be displayed. Press the OK button to
clear the warning message.
The warning message will read “Not enough Memory
Space in System Memory”.
The Project size must be less than 10 MByte for
6”-10” panels and less than 40 MByte for 12” & 15”
panels.
This warning message will be displayed if the restore
Memory device fails or is removed during the backup.
Press the OK button to clear the warning message.
The warning message will read “Restore Failed.
“%Device% cannot be found”.
%Device% will show show “SD1”, “SD2”, or “USB”.
Try using a different device with known good data in
the same connector or using the device that is causing
the error in a different connector.
For any other reason the restore fails, then this
warning message will be displayed. Press the OK
button to clear the warning message.