Do you have a question about the Autonics PSA Series and is the answer not in the manual?
Model | PSA Series |
---|---|
Category | Accessories |
Type | Protective Cover |
Compatible Devices | Autonics sensors |
Thread Type | Please check the individual model specifications for thread type details. |
Weight | Please check the individual model specifications for weight details. |
Details pressure ranges, hysteresis, repeat error, and response time.
Describes control output, analog output, display method, and available pressure units.
Configures the output behavior (e.g., Hysteresis, Window mode).
Details setting St1 and St2 for hysteresis and independent output modes.
Explains setting St1 and St2 for hysteresis mode with output timing.
Describes operation for independent, opposite, and cross output modes.
Covers changing display unit and selecting output modes.
Explains key lock, zero point adjustment, and peak/bottom hold.
Lists error codes, descriptions, and countermeasures for sensor errors.
Instructions for installing the PSA sensor, including port connections and mounting.
Important warnings about using the sensor with corrosive gas, noise, and flammable gas.
Highlights 1/1000-1/2000 resolution, auto-shift, independent outputs, and connector type.
Details model selection codes for PSAN series, including pressure type and output options.
Details pressure ranges, hysteresis, repeat error, and response time for PSAN.
Describes PSAN control output, analog output, display method, and units.
Configures output operation mode and output type for PSAN.
Setting hysteresis levels (SE1, SE2, HY51, HY52) for PSAN.
Important warnings regarding the use of PSAN series sensors.