NOTE
3
●
●
●
●
●
●
●
●
Press the "M" key to switch the four test modes.
Press the "Lighting" key to turn on or off the light
beside the probe.
Mode 1 (Voltage test)
(Voltage test.)
Mode 2 (Continuity test)
(Open- circuit, closed-circuit,virtual circuit and
real circuit can be detected.)
Mode 3 (Polarity test)
(Determine the positive and negative poles, the
positive pole means the green light is on, and
the negative pole means the red light is on.)
Mode 4 (Temper
ature test)
(A temperature sensor is installed at the tip to
detect the temperature of the designated
contact.)
Please do not use it around the environment with
combustible gas, dust and flammable and
explosive atmosphere. And the BT210 should
not be used for all alternating current, or direct
current that is greater than 30V.
Our products are made of long-lasting and durable
materials, and we insist on perfect production
process. Eac
h product leaves the factory after 35
procedures and 12 times of testing and inspection
work, which ensures that each product has
excellent quality and performance.
To maintain the performance and appearance of
the product, it is recommended that the following
product care guidelines be read carefully:
After power on, the lighting will be turned on by
default and can be turned on or off manually by
pressing the key.
Be careful not to rub the product against rough
surfaces or wear the product, especially the
sheet metal housing.
Please regularly check the product parts that
FUNCTIONS AND USAGE
MAINTENANCE SERVICE
Test modes introduction
Introduction to function keys
Maintenance
Probe Tip
Probe Tip
Polarity Indicator Light
Modes Switch
LED Continuity Indicator
Earth Clamp(ground)
Light
Display
Lightning
A B
C D
E F
G H
I
Be careful not to rub the product against rough
surfaces or wear the product, especially the
sheet metal housing.
Please regularly check the product parts that