(SAFTEY START OPERATION:)
The saftey start feature allows you to press the button 2 times before the
vehicle will remote start or remote shut down. (See Start Feature I-5)
B. TO TURN OFF THE REMOTE START:
When the engine is running (by remote start), if you want to stop it,
1. Press button on the transmitter..
2. Move the optional remote start enable toggle switch to the OFF
position. (If installed)
3. Press the brake pedal
The vehicle will shut down and turn off the parking lights to indicate the
engine has stopped.
C. TO OPERATE THE VEHICLE WHILE RUNNING ON THE
REMOTE START:
To operate the vehicle while running with the remote start ON:
1. Insert the ignition key and turn it to “ON” (not the start) position.
2. Press the brake pedal.
Note: If the brake pedal is pressed before the key is in the ON position, the
engine will shut down.
D. TEMPORARY STOP FEATURE:
This feature allows the vehicle to remain running after the key has been
removed from the ignition. This feature is useful for occasions when you
wish to exit and lock the vehicle for short periods of time, but would like to
leave the motor running and the climate control on.
1. Before turning off the engine, press the button on the transmitter
and the LED indicator will flash 3
times to confirm enter.
2. Turn the ignition key to OFF position. (The engine will stay running.)
3. The engine will run until the pre-programmed time elapsed or shut-
down input is received.
E. TIMER START:
This unit can be programmed to start and run the engine every 3 hours.
The engine will run for the programmed run time and then shut down.
IMPORTANT: Timer Start should be used only in open areas; Never start
and run the vehicle in an enclosed space such as a garage or carport.
3 hours timer start: This feature is design for an extreme cold climate
usage. The system will auto start the vehicle every 3 hours, to prevent
engine freezing and hard to start. A MAXIMUM OF SIX CYCLES CAN
OCCUR.
To Next Page
Loading...
