Need help?Do you have a question about the Autronica AutoPath HC800 and is the answer not in the manual?
General| Brand | Autronica |
|---|---|
| Model | AutoPath HC800 |
| Category | Gas Detectors |
| Language | English |
Explains how the AutroPath HC800 transmitter and receiver modules work together to detect hydrocarbon gas.
Lists the hydrocarbon gases and vapors the AutroPath HC800 can detect.
Details the available detection ranges for the AutroPath HC800 system.
Describes using the magnetic switch or external switch for reset and calibration.
Identifies transmitter and receiver modules and their functional differences.
Explains how to reset user configurable parameters to default settings.
Specifies operating and storage temperature ranges for the device.
Defines the measurement range for hydrocarbon gas detection.
Describes heated optics and brow protection for optical surfaces.
Details the NEMA and IP ratings for the device.
Explains the importance of identifying target vapors for calibration and location.
Guides on selecting optimal mounting locations and beam path requirements.
Discusses the importance of mounting modules at the same elevation for alignment.
Advises on avoiding locations with high levels of contaminants.
Details offsets and mounting for flat surface conversions.
Details offsets and mounting for pole conversions.
Provides advice on using the HART communicator with the AutroPath HC800.
Explains how to check the detector's gain level using HART or Modbus.
Overview of span and zero calibration requirements.
Details the one-step clean air adjustment process.
Provides key notes and considerations before performing calibration.
Describes using the onboard magnetic switch for calibration.
Describes using an external switch for calibration initiation.
Details the sequence of events during zero calibration.
Recommends periodic inspection to ensure unobstructed path.
Instructions for cleaning the optical surfaces using isopropyl alcohol.
Procedure for replacing the transmitter module.
Procedure for replacing the receiver module.
Part numbers for alignment tools.
Part numbers for spare components.
Contact information for ordering assistance.
Lists general conditions for safe installation and use under ATEX.
Provides safety notes for specific ambient temperature conditions.
Lists relevant ATEX standards the device complies with.
Specifies accuracy per EN 60079-29-4 standard.
Discusses how misalignment affects accuracy limits.
Lists relevant IECEx standards the device complies with.
Lists general conditions for certification.
Provides safety notes for specific ambient temperature conditions.
Specifies accuracy per IEC 60079-29-4 standard.
Specifies the response time T90.
Discusses how misalignment affects accuracy limits.
Details SIL 2 capability and reference to Safety Reference Manual.
Type Approval Certificate details for compliance with DNV rules.
Shows location classes for HC800 approved by Autronica.
Steps to connect the HART communicator to the AutroPath HC800.
To Next Page