Need help?Do you have a question about the Autronica AutroSafe BSD-340 and is the answer not in the manual?
General| Brand | Autronica |
|---|---|
| Model | AutroSafe BSD-340 |
| Category | Measuring Instruments |
| Language | English |
Important safety warnings for product installation and operation.
Legal disclaimers regarding product warranties and representations.
Explains saving loop topology to EEPROM for control and identification.
Details a new fault message related to topology saving or EEPROM corruption.
Lists other software improvements in version 1.1.0, affecting loop handling.
Specifies software version compatibility between BSD-340 and AutroSafe IFG.
Lists compatible loop unit software versions for BSD-340.
Compares PowerLoop functionality with standard detector loops.
Details the PowerLoop system, its electrical properties, and software handling.
Details the electrical specifications of the PowerLoop system.
Explains the "raising" process for a PowerLoop and special cases.
Discusses the importance of loop wiring and cable length for PowerLoops.
Describes loop handling procedures including topology reporting and reset.
Describes how the BSD-340 reports loop topology during AutroSafe INIT.
Explains the process of loop handling and reset for fault resolution.
Details how AutroSafe polls detectors to ensure they are active.
Defines crosstalk and its impact on PowerLoop communication.
Lists potential problems arising from crosstalk events.
Outlines methods to mitigate crosstalk issues in PowerLoop systems.
Explains how duplicate messages are handled and their potential impact.
Pre-upgrade steps, including downloading files and checking system numbers.
Instruction on labeling the board with the target SW version for upgrade.
Guide for physically connecting a PC to the BSD-340 service port.
Steps to launch and establish a connection using the IFG Service Tool.
Instruction to disable the loop on the Autrosafe panel before upgrade.
Detailed steps for downloading EEProm and Application files to the BSD-340.
Procedures for raising the loop and saving its topology to EEPROM.
Procedures for deleting and saving loop topology.
Methods for deleting existing loop topology from the driver.
Procedures for saving a new loop topology.
Procedures for replacing the BSD-340 PowerLoop driver.
Steps to replace the BSD-340 driver without using PC software.
Steps to replace the BSD-340 driver using the IFG Service Tool.
Procedures for replacing a loop unit.
Instructions for replacing a loop unit without PC software.
Instructions for replacing a loop unit using the IFG Service Tool.
Lists and describes essential commands for commissioning.
Procedure to establish communication on the AutroFieldBus.
Procedures for de-conflicting systems and PowerLoops.
How to change system numbers to avoid conflicts between PowerLoops.
Details on crosstalk detection, management, and analysis.
Explains the purpose of the +40 setting for crosstalk management.
Method to detect and identify crosstalk issues.
Visual representation of crosstalk detected between loops.
Command to display statistics for crosstalk on a specific loop driver.
Command to display internal statistics of the PowerLoop driver.
Using serial numbers and topology listing for verification.
Troubleshooting steps for simultaneous open loop and short circuit issues.
How to resolve parameter faults on loop units.
Warning against enabling loops without saved topology due to potential issues.
Causes and resolution for memory faults after initialization.
Troubleshooting open loop issues that occur after initialization.
To Next Page
