Need help?Do you have a question about the Autronica AUTROSAFE 4 and is the answer not in the manual?
General| Brand | Autronica |
|---|---|
| Model | AUTROSAFE 4 |
| Category | Measuring Instruments |
| Language | English |
Describes parameters like Loop Unit and Loop Sequence Index (LSI) used in consistency checks.
Describes using the AS-2000/Config Mismatch Tool to compare configuration data.
Details addressing Power Boards (BSF-400) using rotary switches and dipswitches.
Explains configuration using rotary switches (X10, X11) and dipswitch (S5/S6).
Explains assigning unique AutroFieldBus addresses to units using rotary switches.
Details the function of dipswitches S5 and S6 for configuration.
Outlines the calibration procedure for Power Unit BPS-410 to ensure correct charging voltage.
Explains how rotary switches X5 and X3 determine the panel's Network ID.
Details assigning unique Panel IDs using rotary switches (X6, X4) and dip-switch S2.
Describes how to apply power to the system for the first time and the expected display information.
Describes how to assign IP addresses, either automatically or manually.
Details how selecting Automatic Addressing Mode assigns default IP addresses to panels.
Explains how to manually set IP addresses considering existing network components.
Describes uploading configuration files to panels from a central point using a USB stick.
Outlines steps to verify the entire system (panel, detectors, functions) after an upload.
Details upgrading system software and configuration via the Service Menu.
Describes the initial startup procedure for systems with Primary and Secondary AutroSafe Dual Safety concepts.
To Next Page
