Introduction
Table of Contents
1. Introduction ...................................................................... 5
1.1 About the Handbook .......................................................................... 5
1.2 The Reader ....................................................................................... 5
1.3 Reference Documentation................................................................. 6
2. Quick Reference Guide ................................................... 7
2.1 Initial Commissioning ........................................................................ 7
2.2 Upgrading System Software and Configuration ................................ 7
3. Verifying the Loops ......................................................... 8
3.1 AS-2000 Loop Diagnostic Tool ......................................................... 8
3.2 Verification Procedure ....................................................................... 8
4. Consistency Check of Configuration Data ..................... 9
4.1 Introduction ........................................................................................ 9
4.2 Parameters Used for the Consistency Check ................................... 9
4.3 Importing Loop Data from the AS-2000 Tool .................................... 10
4.4 Consistency Check Using the AS-2000 / Config Mismatch Tool ..... 10
4.5 Generating Configuration Files ......................................................... 10
5. Power Commissioning .................................................... 11
5.1 Addressing Power Boards on the AutroFieldBus .............................. 11
5.1.1 Switch Settings on Power Board BSF-400 ............................. 11
5.1.2 Location of Switches ............................................................... 11
5.1.3 AutroFieldBus Addresses ....................................................... 13
5.1.4 Power Board Configuration Switches ..................................... 14
5.2 Calibration Procedure - Power Unit BPS-410 ................................... 15
6. Addressing Panels .......................................................... 16
6.1 Definitions .......................................................................................... 16
6.1.1 Network ID .............................................................................. 16
6.1.2 Panel ID .................................................................................. 16
6.2 Location of Switches ......................................................................... 17
6.3 Assigning Network IDs ...................................................................... 18
6.4 Assigning Panel IDs .......................................................................... 19
7. Verifying the System Before Startup .............................. 21
8. Startup Procedure ........................................................... 22
8.1 Applying Power to the System .......................................................... 22
8.2 IP Number Structure .......................................................................... 24
8.3 Assigning IP Adresses ...................................................................... 24
8.3.1 Automatic Addressing Mode ................................................... 25
8.3.2 Manual Addressing Mode ....................................................... 27
To Next Page
Loading...
