Introduction
Commissioning Handbook, AutroSafe Interactive Fire Detection System, Release 4, 116-P-ASAFE-COMMISS/EGB Rev.F, 2014-04-01,
Autronica Fire and Security AS
Page 4
8.3.3 Configuration Missing.............................................................. 28
8.4 Configuration File .............................................................................. 29
8.4.1 Name, Format and Extension ................................................. 29
8.4.2 Copying the Zip File to a USB Stick ........................................ 29
8.5 Uploading Configuration Files to the System .................................... 30
8.6 Configuration Mismatch ..................................................................... 33
8.7 Entering Required Access Levels ..................................................... 34
9. Verifying the System after an Upload ............................. 36
9.1 General System Verification Procedure ............................................ 36
9.2 Verifying Detection Loops During Normal Operation ........................ 37
10. Upgrading the System ..................................................... 38
10.1 Introduction ........................................................................................ 38
10.2 Upgrading During Normal Operation (SW/Config) ............................ 38
10.2.1 Introduction ............................................................................. 38
10.2.2 Upgrading Software During Normal Operation ....................... 39
10.2.3 Upgrading Configuration During Normal Operation ................ 39
10.3 Upgrading when Panels are Added/Removed .................................. 40
10.4 Upgrading if IP Addresses are to be Changed.................................. 40
10.5 Upgrading a Single Panel.................................................................. 40
10.6 Upgrading by Remote Access to a Web site..................................... 41
10.7 Upgrading Software Version 4.0.1 to 4.1.1 ....................................... 42
10.7.1 General ................................................................................... 42
10.7.2 Preparing a System in Normal Operation ............................... 42
10.7.3 Preparing a System in System Fault Condition ...................... 43
10.8 Upgrading Software Version 4.0.1 or 4.1.1 to 4.3.1 .......................... 44
10.8.1 Example 1: Upgrading all Panels from SW Version 4.0.1
or 4.1.1 to 4.3.1 ...................................................................... 44
10.8.2 Example 2: Adding a BS-420/BS-430 panel with SW
Version 4.1.1 to a System Running on SW Version 4.3.1 ......
44
10.8.3 Example 3: Adding a BC-420 Controller with SW Version
4.1.1 to a System Running on SW Version 4.3.1 ................... 44
10.8.4 Example 4: Adding a Panel with SW Version 4.3.1 to a
System Running on SW Version 4.1.1.................................... 45
11. Startup Procedure for a Dual Safety System ................. 46
11.1 Introduction ........................................................................................ 46
11.2 Guidelines – Startup Procedure ........................................................ 47
12. Fault Messages during Uploading .................................. 49
12.1 Introduction ........................................................................................ 49
12.2 Invalid File on USB Stick ................................................................... 49
12.3 Data Transmission Timeout .............................................................. 49
12.4 Corrupt File ........................................................................................ 49
12.5 Fail to Unpack Files ........................................................................... 50
To Next Page
Loading...
